Static Control Bars for Industrial, Medical, Printing and Converting Industries

C.C.Steven & Associates, 1363 Donlon Street Ventura, CA 93003   since 1978  

ph:  805-658-0207          fax: 805-658-2789           static@ccsteven.com

[CCSteven.com] [Static Control] [StaticBars] [MESB125 Bar]

MESB125 Static Bar The MESB125 is a "hot" static bar with a rigid brass casing, which makes it well suited for rugged industrial environments. The bar is for use where peak performance is critical and contact with the bar by personnel is unlikely. The MESB125 requires a power supply for operation, which must be ordered separately. UL and CSA approved. FAQ     Static Bar Comparison Chart     Dimensional Drawing(74kB)     Return to Static Bars

Specification: Shockless or Hot Hot Ionization Output Very High Maximum speed of target material 1500 ft/min How far from charged material can bar be mounted? 1 inch Approved for hazardous locations No Intended for heavy, normal or light industrial applications Any Maximum overall length 180 inches Design Your MESB125 Static Bar It's easy to configure and order a Simco MESB125 static bar to fit your requirements. They are available in 1” increments starting with overall lengths from  3” with a single ionizing emitter pin up to 150” with 147” of ionizing emitter pins. All SIMCO static bars are shipped with mounting brackets, high voltage cable and a connecter to attach the cable to a SIMCO Power Supply. Standard high voltage cable length is 10-ft. Longer lengths can be made if required. We can also add a right angle cable exit to the bar to facilitate the cable run. Simply select the overall length of the static bar you need, determine if additional cable length is required to reach the power supply mounting location, and decide if the right angle cable exit is wanted.    Then E-mail us or call C.C. Steven at 805-658-0207 and we’ll get on built for you! Check our Demonstrator Page for super deals ( 50% or more off list ) on demonstrator units we may have available. You must order a power supply to power the static bar if you do not already have one. We recommend the following models for the MESB125 Static Bar. Power Supply Part Number S166S - 120V, 50/60 Hz, 2-output, lighted power switch IPS2000 S266S - 230V, 50/60 Hz, 2-output, lighted power switch IPS2001 N165 - 120V, 60 Hz, 4-output, lighted power switch IPN0511 N265 - 230V, 60 Hz, 4-output, lighted power switch IPN0513

Visit our other sites to further enhance your manufacturing operations.  Click on a button below: