|
 R50 Blue Bar ( top bar in picture at left )
NEW: Warranty Extended to 30 Months
Now Available Moisture Resistant !
The Blue Bar is a super high-output, rugged, shockless static bar which can be used in almost any application requiring a
static bar. The bar is especially useful for high speed applications and is effective at web speeds of 2500' per minute or more. The bar delivers long range
static elimination, and can be located up to 6" (and sometimes more!) from the target material.
The patented Blue Bar is designed for easy cleaning and offers a mounting channel with full length
adjustment. The bar's high voltage cable is metal shielded, which controls EMI and RFI emissions, eliminating interference with external controls and circuitry. The R50 includes a high voltage cable which
is permanently attached to the bar. If you want a detachable cable, order the R51 instead.
The Blue Bar can be powered by the NEW TrueAC Self Monitoring Power Supply or D167Q/D257Q Power Supply, which must be ordered separately. The TrueAC Power Supply gives you Bar ON Indicator
, Bar OFF Indicator, CLEAN BAR Indicator, FAULT Indicator with arc detection circuit protection for the transformer, SERVICE Indicator, BAR PERFORMANCE Display, and Remote Display capabilities. The
M167 Power Supply includes a monitoring system to detect arcing conditions and short circuit on the ionizing points and the cable. Indicator lamps verify input and output voltage status as well as arc
detection. Optional remote failure signals are available for external monitoring of these features.
The R50 BlueBar can be made “ moisture resistant” not waterproof. The bar cannot be immersed in
water or subjected to constant washdown. However, it will withstand occasional contact with water, such as splashing or an infrequent washdown when an operator forgets to remove the bar from the wash
down area. It will also function in high humidity environments.
Prototypes ran continuously (24/7) for over eight months in a 100% humidity environment before burnout.
This is equivalent to almost three years of operation 8 hours per day, 5 days per week.
FAQ Static Bar Comparison Chart Dimensional Drawing(25kB) Return to Static Bars
|
|
|
Specification:
|
Shockless or Hot
|
Shockless
|
|
Ionization Output
|
Very High
|
|
Maximum speed of target material
|
2500 fpm and more
|
|
How far from charged material can bar be mounted?
|
up to 6 inches
|
|
Approved for hazardous locations
|
No
|
|
Intended for heavy, normal or light industrial applications
|
Any
|
|
Maximum overall length
|
156 3/4 inches
|
|
Design Your R50 Blue Bar
It's easy to configure and order a Simco R50 BlueBar static bar to fit your requirements. They are
available in 0.59” increments starting with overall lengths from 3.34” with a single ionizing emitter pin up to 156.30” with 152.95” of ionizing emitter pins. All SIMCO static bars are shipped with mounting
brackets, high voltage cable and a connecter to attach the cable to a SIMCO Power Supply. Standard
high voltage cable length is 7-ft. Lengths of 14-ft and 21-ft can be made if required. We can also add a right angle cable exit to facilitate cable routing.
Simply select the overall length of the static bar you need, determine if additional cable length is required
to reach the power supply mounting location, and if a right angle cable exit is desirable. Then E-mail us or call C.C. Steven at 805-658-0207
and we’ll get one built for you!
Check our Demonstrator Page for super deals ( 50% or more off list ) on demonstrator units we may
have available.
You must order a power supply to power the static bar if you do not already have one.
|
