BlueBar HL

This product is being discontinued effective 3-31-12.  Please refer to the perforMAX IQ HL as its replacement

The Blue Bar HL Static Neutralizing Bar is a high  efficiency, extended range, shockless static bar UL listed for use in Class I  (Division 1 and 2, Group D) Class II (Division 1 and 2, Group G) and Class III  (Division 1 and 2) hazardous locations. The Blue Bar HL neutralizes static  charges on webs at speeds to 2,500 fpm at 1” and can be mounted up to 6” from  the web at slower speeds. It’s patented design allows for easy cleaning and  offers a mounting channel along the full length of the back of the bar. The Blue  Bar HL is ideal for use in hazardous areas including coating, laminating,  finishing and gravure printing.

There are two power supply choices for  the Blue Bar HL. The XP167 (120V) and XP267 (230V) are UL/CUL approved for  mounting inside Class I (Division 1 and 2, Group D) hazardous locations. These  power supplies have an arc detection circuit to shut down the power supply  within 40 milliseconds in the event of an arc from the bar or cable. They also  have indicator lights (located inside the power supply housing) to indicate if  there is high voltage output and if a shut-down has occurred. Relay contacts  allow remote display of the indicator lights. The XPM167 (120V) and XPM267  (230V) have the same features as the XP167 and XP267, but the units are UL/CUL  approved for mounting only outside the hazardous area.

We recommend that you call C.C. Steven at 805-658-0207 if you are not already familiar with installing and operating this equipment.

UL Listed for Class I, Division 1 and 2, Group D hazardous locations and FM approved.
FAQ     Static Bar Comparison Chart    Dimensional Drawing with Specifications(812kB)
Return to Static Bars

It's easy to configure and order a Simco BlueBar HL static bar to fit your requirements. They are available in 0.59” increments starting with overall lengths from  3.34” with a single ionizing emitter pin up to 156.89” with 153.54” of ionizing emitter pins.  Standard high voltage cable length is 10-ft.  Longer lengths can be made if required. 
Simply select the overall length of the static bar you need and determine if additional cable length is required to reach the power supply location    Then E-mail us or call C.C. Steven at 805-658-0207 and we’ll get one built for you!

You must order a power supply to power the static bar if you do not already have one. We recommend the following models for the BlueBar HL Static Bar.

Power Supply	Part Number
XP167 - 120V, 60 Hz, 7 kV, 3mA max, 4 output, use inside hazardous area	IPS0600
XP267 - 230V, 60 Hz, 7 kV, 3mA max, 4 output, use inside hazardous area	IPS0601
XPM167 - 120V, 60 Hz, 7 kV, 3mA max, 4 output, use outside hazardous area	IPXPM01
XPM267 - 230V, 60 Hz, 7 kV, 3mA max, 4 output, use outside hazardous area	IPXPM02